If you can hear water squish under your feet or see it pooling against the baseboards, the job right now is getting liquid out, not drying air. One call to Water Heater Repairer routes you to a licensed and insured independent local pro in Janesville who brings serious extraction gear.
Extraction is the single step that most affects how long the rest of the job takes and how much of your flooring can be saved.
The pros we route to carry liability insurance and the required local license, which matters when hoses and pumps are running through your house.
Standing water climbs drywall and slides under walls every hour it sits, so the nearest open unit gets the call.
Before hoses go down, the contractor gives you a written, flat-rate quote for extraction and explains what is and is not included.
Truck-mounted units, weighted extraction tools and submersible pumps move far more water than any shop vac.
The physics here is not complicated. Pulling water out as liquid is many times faster than waiting for it to evaporate, and every gallon removed by a wand is a gallon the dehumidifiers never have to handle. That is why the extraction pass is the most important hour of the whole job.
Experienced operators take their time here. Expect slow, overlapping strokes while the operator watches the sight glass and keeps going until the flow dies off. After that, they check adjoining rooms, since water seldom stops at the threshold. On the call we ask about depth, flooring and parking so the right setup arrives on the first trip.
The right tool depends on how deep the water is, what flooring it is on, and whether it has reached the pad.
A truck-mount runs off its own engine and pulls far stronger vacuum than portable gear, with a hose run through a door or window. They are the go-to for big carpeted spaces.
Upper-floor condos, long hallways and buildings without driveway access get portable extractors carried inside. They are slower than a truck-mount but reach places a long hose cannot.
Surface wands only reach the face of the carpet. Ride-on and weighted tools press down with the operator's weight to wring water from the pad, which can make float-and-dry a real option.
When water is more than an inch or two deep, a submersible pump goes in first to drop the level fast. Once the pump loses prime, wands and extractors finish the job.
Hard floors get squeegeed toward one collection point, then lifted out with a wand or a small pump. Wood floors get quick extraction and drying mats when they can be saved.
Water slides under walls and into the next room, often without any visible sign. The pro scans with a pinless meter and thermal camera to locate the wet perimeter before finishing.
Give us the approximate depth, the flooring type and whether the source has been stopped. That decides whether a pump, a truck-mount or a portable unit goes out.
First, the pro checks that the water source is shut and that wet outlets are not live. Then the extraction equipment goes into position.
A quick moisture map shows how far the water traveled, and the pro tests whether the pad can be floated and dried or must be pulled. You get a written quote before extraction begins.
Passes continue until no more water comes up, and the recovered gallons are logged. You sign off and the job moves to drying with a written handoff.
If a pipe or appliance is the cause, close the main shut-off. If water is near outlets or cords, turn off that circuit at the panel, but only if you can reach the panel without standing in water.
Set furniture legs on blocks or foil squares to stop rust and dye from bleeding into the carpet. Move rugs, electronics and paper boxes off the floor.
This is the question callers ask most, and the answer depends on the water and the time.
| Situation | Usual approach |
|---|---|
| Clean water, caught quickly | Subsurface extraction followed by floating the carpet and drying in place |
| Clean water, sat a day or more | Pad usually removed, carpet extracted and dried |
| Gray water from appliances | Pad discarded, carpet sanitized and judged case by case |
| Sewage or outside floodwater | Both carpet and pad come out and go to disposal |
Call now and get a local extraction unit headed your way.
Our washing machine hose burst while we were at work and the whole living room carpet was soaked. The contractor went over the carpet slowly with a ride-on tool, and you could see water pouring through the clear wand. The carpet got floated and dried, and we kept it.
Our sump pump died in a storm and left roughly four inches standing in the basement. The pro started with a submersible pump discharging far from the house, then moved to wands when the level dropped.
I am on the third floor of a condo building with no driveway access at all. They brought portable extractors up the elevator and used a thermal camera to show the water had already gone under the wall into the hallway closet.
The ice-maker line behind our fridge leaked overnight onto the kitchen tile and under the wall into the dining room carpet. The pro squeegeed the tile to one corner, wanded it up, then ran the weighted tool on the dining room side where nobody had even noticed it was wet.
A wet vac helps with a small spill, but it holds only a few gallons and has no way to pull water from the carpet pad. For anything beyond a small area, professional extraction removes far more water in far less time.
Not always. With clean water caught early, weighted extraction can squeeze the pad enough to float and dry the carpet in place. With gray or black water, the pad is almost always removed.
The pro uses a pinless meter through the surface and a thermal camera to spot cold, damp areas hidden from view. Combined, these tools trace the full spread.
Truck-mounts are engine-powered with much higher suction, ideal for big ground-level losses. Portables run on house power and handle upper floors and spots a truck hose cannot reach.
No. Extraction removes liquid water, while drying uses air movers and dehumidifiers to pull out the moisture left in materials. Thorough extraction often shortens drying by days.
Yes, given enough time. Once water gets through the pad, it soaks the plywood or OSB, and particleboard underlayment may swell quickly. Fast subsurface extraction gives the subfloor the best chance of drying flat.
The pros we dispatch work throughout Janesville and nearby towns at any hour. Service areas include zip codes such as 56048.
Single-family homes with driveway access for truck-mounted units.
Multi-story buildings reached with portable units carried upstairs.
Lower levels where a failed sump leaves standing water across the floor.
Call Water Heater Repairer now to get a local extraction unit moving toward you. An early extraction pass usually means more carpet and pad can be saved.
Call +1-877-637-9008
